Digital meter selection: display examples

DM96 devices provide motor monitoring and configured protection for compatible starter or contactor control circuits. They stop the control output when the configured electrical fault conditions are detected. Choose the function package for your pumping plan and have the device matched to the existing starter arrangement.

Choose an SP model for a compatible single-phase installation and a TP model for a compatible three-phase installation. TP versions also provide phase-loss and phase-sequence detection. Match the supply and control circuit first, then select the cyclic, clock or level-control package you need.

DM-SP-CYC-96 and DM-TP-CYC-96 combine motor protection with repeated ON/OFF cyclic scheduling. Their listed functions also include an Auto-Off Stop Timer and power-on start delay. Choose CYC for time-based operation with tank level managed separately, and set the timing for the motor and water source.

The LLC variants combine automatic tank-level control with cyclic timing. This suits a pumping plan where the receiving tank’s level should influence operation. Choose the matching SP or TP version and have the connected level inputs, sensor positions and wiring set up for that plan.

The CCCT variants combine motor protection with clock and cyclic scheduling. They suit timed operation using chosen times of day or a repeating run/rest pattern, with tank level managed separately. Select the supply-phase version and configure the chosen timing mode for your pumping requirement.

RTLC combines water-level control with clock and cyclic functions. This suits a plan that needs tank demand together with time-of-day scheduling. Select the correct phase version, then configure the level inputs and level-control operating hours as part of one site setup.

The current models list power-on start delay and timer power-failure recovery. These functions can be configured as part of the intended operating mode for the pump. Confirm the selected mode’s interrupted-run behaviour during commissioning so the daily pumping plan has clear restart settings.

Use the footage to understand display and control types, and use the current DM96 product details for the exact device choice. The selected model’s mounting requirements, supply and diagram are the references for fitting it to an existing panel. Bring those details together with the installer before choosing the device.

Set the voltage, current, dry-run and timer parameters for the connected pump and supply. That makes the monitoring and control values specific to the installation. Have a qualified electrician check the settings and any fault cause before returning the motor to operation.

Fault-code guide

The current DM96 models list a fault counter and cumulative run-time counter. Recording those readings with the device and motor identity gives useful operating information for maintenance discussions. Confirm the selected device’s counter and reset behaviour, and keep dated readings so any service-history comparison uses a clear baseline.