3 Phase Digital DOL Starter Panel with Auto Switch, Motor Safety, Cyclic Timer & Clock Timer (TPM-T) VUKAR

3 Phase DOL Starter Panel Supplier for Waluj

Mohit Vekaria

For a 3 phase DOL starter panel in Waluj, compare VUKAR TPM-T when a compatible clean utility-water pump needs fixed operating hours. Confirm which stops depend on the clock and which depend on tank level.

Give each Waluj water line a name

Maharashtra’s industrial water inventory lists Waluj. The Pollution Control Board separately records a common effluent treatment plant there. On the plant drawing, label the clean utility transfer line and keep the effluent duty outside this quote. If the work order only says water pump, the supplier cannot tell which equipment is changing. Ask the plant engineer to put the actual fluid, pump tag and the receiving tank on the quote request. Then mark the shift window for this pump alone.

Waluj industrial water inventory · Waluj common effluent treatment record

What should happen at 08:00 and 08:30?

Suppose maintenance permits pump operation from 08:00 to 08:30. A timer can provide a time window. Agree separately what should happen at 08:00 if the inlet tank is still low and at 08:30 if the receiving tank needs water.

Condition What to agree
Start of window Confirm the source tank can supply water
Tank fills early Ask for the separate stop needed at full
End of window Agree who handles an unfinished fill

Before you order

Write three decisions before choosing any timing setting. First, who decides the hours when the pump may operate? Second, what should stop a run early? Third, who is responsible if power or water is lost during the run? Read those decisions to the supplier and ask which ones the exact model can handle with the proposed sensors and starter. Confirm any remaining operator action with the person who will do it. During handover, ask for a demonstration of a normal cycle and an interrupted one. Record whether the next run is permitted, delayed or left for the operator to approve.

Related guide · DOL Starter Panel: Three-Phase Digital Controls and Selection

VUKAR TPM-T product detail
VUKAR TPM-T product detail

Product and quote

Give the electrician the shift window, motor plate and a sketch of both tanks. Ask the supplier to list which time controls are included and which level inputs or other controls belong in the site design.

Draw the water route before you label the signals. Mark the source, the pump, the receiving tank and any other inlet. On the drawing, put a mark where each level sensor is meant to act. Ask the installer to show what happens if water is low at the source while the receiving tank still needs water. Then ask to see what happens when the receiving tank is full. If another inlet can still fill the tank, give that inlet its own stop decision. This drawing also shows the supplier the cable route and which signals actually belong on the quotation.

Compare the installed job, using the same scope for each seller. Ask for the exact model and variant, the included parts, the cost of field cable and any mounting work. Ask who supplies the sensors and who returns if a setting needs correction. A lower panel price can leave out the part of the job that brings the pump back into service. Write the test you expect alongside the price. That makes it clear whether one supplier has quoted equipment only and another has also included fitting, setting up the controls and demonstrating them to the person who operates the pump.

Ask for a quote

Back to blog