News

OPM-C recommended parameter settings cover for openwell cyclic timing and protection.

Recommended OPM-C Settings: Openwell Run/Rest and Motor Protection

Record the two cyclic timer values for the selected mode, using the labels shown on your installed revision, and record the commissioned overload, dry-run and voltage protection settings.

Recommended OPM-C Settings: Openwell Run/Rest and Motor Protection

Record the two cyclic timer values for the selected mode, using the labels shown on your installed revision, and record the commissioned overload, dry-run and voltage protection settings.

OPA-T recommended parameter settings cover for openwell tank levels and clock scheduling.

Recommended OPA-T Settings: Openwell Tank Levels and Clock Scheduling

Confirm the low and full tank switching points, set the clock and enabled weekdays for the approved schedule, and keep the RUN/RST and protection values in the commissioning record.

Recommended OPA-T Settings: Openwell Tank Levels and Clock Scheduling

Confirm the low and full tank switching points, set the clock and enabled weekdays for the approved schedule, and keep the RUN/RST and protection values in the commissioning record.

OPA-H recommended parameter settings cover for openwell tank levels, cyclic timing and ast.

Recommended OPA-H Settings: Tank Levels, Cyclic Timer and Start Delay

Confirm the openwell installation’s low and full tank responses, record RUN and RST for its approved cyclic mode, and document the AST delay if automatic starting after power returns was...

Recommended OPA-H Settings: Tank Levels, Cyclic Timer and Start Delay

Confirm the openwell installation’s low and full tank responses, record RUN and RST for its approved cyclic mode, and document the AST delay if automatic starting after power returns was...

OPA-B recommended parameter settings cover for openwell filling and run/rest timing.

Recommended OPA-B Settings: Openwell Tank-Level Control and Run/Rest

Record the receiving tank’s low and full switching points and the selected filling mode. Where the openwell installation uses a repeating cycle, record the approved run and rest minutes and...

Recommended OPA-B Settings: Openwell Tank-Level Control and Run/Rest

Record the receiving tank’s low and full switching points and the selected filling mode. Where the openwell installation uses a repeating cycle, record the approved run and rest minutes and...

BOM-W recommended parameter settings cover for level indication, timed stop and protection.

Recommended BOM-W Settings: Level Indication, Timed Stop and Protection Defaults

Check the indicated tank level against the actual tank, record the approved RUN duration, and keep the commissioned current and voltage protection limits. Keep a separate note of breaker state...

Recommended BOM-W Settings: Level Indication, Timed Stop and Protection Defaults

Check the indicated tank level against the actual tank, record the approved RUN duration, and keep the commissioned current and voltage protection limits. Keep a separate note of breaker state...

BOM-V recommended parameter settings cover for level display and run timed stop.

Recommended BOM-V Settings: Tank-Level Display and RUN Timed Stop

Record what the tank level display shows at known water levels and save the RUN duration in minutes for the approved timed-stop mode. Keep the motor protection limits and delays...

Recommended BOM-V Settings: Tank-Level Display and RUN Timed Stop

Record what the tank level display shows at known water levels and save the RUN duration in minutes for the approved timed-stop mode. Keep the motor protection limits and delays...

Read VUKAR guides on pump controls and starter panels. Our products come from manufacturer Vukar Automation in Rajkot, Gujarat.