Control Panel Supplier in Vapi
Mohit VekariaShare
If you need a Control Panel Supplier in Vapi, SubmersibleShop.com offers the VUKAR TPO-H for a compatible three-phase openwell or monoblock pump that moves clean utility water. It can fit a job with a source tank, a receiving tank and a need for automatic level control. First give the supplier the pump tag, the type of water and the two tanks it serves. That lets the quote name the correct equipment.
Industrial pump control panel for a Vapi GIDC unit
The joint monitoring report filed with the National Green Tribunal describes GIDC water from the Damanganga weir for domestic and industrial use in the area it reviewed. The Notified Area Authority identifies Vapi GIDC as an industrial estate. For a buyer, this means the site water drawing matters. Mark the inlet, the storage tank after the inlet and the utility tank that the pump fills. Two plants in the same estate can arrange these tanks differently.
Keep the job to clean utility water. A drain sump or an effluent line can have another duty, another pump and other control needs. In the example here, the panel moves water already stored on site into a clean utility tank. If a requisition just says sump pump panel, add the pump tag and write where the water goes. Take a photo of the pump label as well as a photo of the tank labels.

When a three-phase clean-water pump panel fits
The TPO-H product page lists a built-in MCB, a cyclic timer and two cable floats for compatible openwell and monoblock pumps, with variants up to 10 HP. MCB means miniature circuit breaker. A cyclic timer repeats an on period and an off period. For a transfer job, set out what should start and stop the pump. A repeat cycle and an automatic stop when a tank is full are two different tasks.
Worked example · A full tank before the shift ends
Assume a clean utility tank calls for water at 14:10. The source tank has enough water, so transfer starts. At 14:22 the receiving float shows full and the pump stops. If the source drops too low first, it should stop sooner. Confirm both tests at the site.
| Site condition | What to put in the quote |
|---|---|
| One clean-water pump | Match the motor and request both float signals |
| Drain or process fluid | Give the duty to the site engineer for a separate selection |
| Two pumps share the tank | Describe how each pump is meant to run |
Check the old starter before selecting the variant. DOL means direct-on-line. This method applies the full supply voltage when the motor starts. If the old system uses a drive or star-delta starting, give that detail to the site electrician and supplier. Have them assess the starting arrangement before quoting the panel. A nameplate with the same HP as the old pump is only one part of the comparison.
Source and receiving tank floats have separate jobs
The source float tells the control when the lower tank can no longer supply enough water. The receiving float stops filling when the upper tank reaches its set point. Give the electrician a sketch with the two float locations and their cable routes. Ask how the pump should behave if the water returns after a low-source stop. Agree on that before anyone changes the old panel.
What to send for a Vapi pump panel quote
Send both pump and starter labels, supply voltage, running current, the water type and the required start and stop signals. Include the tank heights, cable routes and a delivery PIN code. Ask the quote to separate the panel, floats, cable, fitting and testing. If a second pump shares the same tank, write down whether the two pumps work in turns. An automatic duty and standby arrangement needs its own review. Ask for a simple record of each test and the result. Mark which person owns the decision to restart after a fault. Before handing the panel back to production, make sure the next shift knows the pump tag and has the same copy of the test record.
Use the three-phase starter panel comparison to compare the models. Then send VUKAR your utility water sketch and motor plate and ask for the exact variant and who will test the stop signals after fitting.