News

DM-SP-LLC-96 recommended parameter settings — VUKAR illustrated guide

Recommended DM-SP-LLC-96 Settings: Single-Phase Tank Levels and Cyclic Timer

On the DM-SP-LLC-96, establish low/full water-level behavior with the installed level input, then commission single-phase protection and cyclic timing for the selected mode.

Recommended DM-SP-LLC-96 Settings: Single-Phase Tank Levels and Cyclic Timer

On the DM-SP-LLC-96, establish low/full water-level behavior with the installed level input, then commission single-phase protection and cyclic timing for the selected mode.

DM-SP-CYC-96 recommended parameter settings — VUKAR illustrated guide

Recommended DM-SP-CYC-96 Settings: Single-Phase Protection and Cyclic Run/Rest

Set DM-SP-CYC-96 overload, dry-run and voltage protection with the electrician, then choose cyclic RUN and RST for the pump’s supply and duty. Use elapsed intervals for this model.

Recommended DM-SP-CYC-96 Settings: Single-Phase Protection and Cyclic Run/Rest

Set DM-SP-CYC-96 overload, dry-run and voltage protection with the electrician, then choose cyclic RUN and RST for the pump’s supply and duty. Use elapsed intervals for this model.

DM-SP-CCCT-96 recommended parameter settings — VUKAR illustrated guide

Recommended DM-SP-CCCT-96 Settings: Single-Phase Protection, Clock and Cyclic Timing

On the DM-SP-CCCT-96, confirm single-phase motor protection first, set the actual clock and active days, then choose the clock event and cyclic durations required by the selected mode.

Recommended DM-SP-CCCT-96 Settings: Single-Phase Protection, Clock and Cyclic Timing

On the DM-SP-CCCT-96, confirm single-phase motor protection first, set the actual clock and active days, then choose the clock event and cyclic durations required by the selected mode.

DEV-H4 recommended parameter settings — VUKAR illustrated guide

Recommended DEV-H4 Settings: Clock Schedule, Tank Levels and Cyclic Timing

Set up and observe both tank signals on the DEV-H4 first. Then set the day, clock window and cyclic durations for the single-phase openwell or monoblock installation.

Recommended DEV-H4 Settings: Clock Schedule, Tank Levels and Cyclic Timing

Set up and observe both tank signals on the DEV-H4 first. Then set the day, clock window and cyclic durations for the single-phase openwell or monoblock installation.

DEV-H3 recommended parameter settings — VUKAR illustrated guide

Recommended DEV-H3 Settings: Tank-Level Mode and First-Fill Checks

Start the DEV-H3 first-fill test by recording the overhead float’s actual low and full switching points. Set the clock and window after that so a timing rule cannot mask a...

Recommended DEV-H3 Settings: Tank-Level Mode and First-Fill Checks

Start the DEV-H3 first-fill test by recording the overhead float’s actual low and full switching points. Set the clock and window after that so a timing rule cannot mask a...

DEV-H2 recommended parameter settings — VUKAR illustrated guide

Recommended DEV-H2 Settings: Tank-Level Mode and Cyclic Timer

Set the two float inputs and tank-level mode before adjusting the DEV-H2 cyclic timer. This model serves listed single-phase openwell or monoblock arrangements with a double float.

Recommended DEV-H2 Settings: Tank-Level Mode and Cyclic Timer

Set the two float inputs and tank-level mode before adjusting the DEV-H2 cyclic timer. This model serves listed single-phase openwell or monoblock arrangements with a double float.

Read VUKAR guides on pump controls and starter panels. Our products come from manufacturer Vukar Automation in Rajkot, Gujarat.