Illustrative disconnected motor and copper windings on a workshop bench

Motor Rewinding Cost: What Should a Repair Quotation Include?

Mohit Vekaria

Motor rewinding cost depends on the motor rating, construction, damage, replacement parts and tests included. As one local reference, Deans Pump Repair in Hyderabad publishes workshop estimates of ₹2,500–₹3,500 for 1–1.5 HP submersible motors and ₹3,500–₹5,000 for 2–3 HP. Its page excludes deep-borewell extraction and reinstallation. Ask for the complete job quote before comparing repair with replacement.

Those figures are one provider's published estimates, checked on 5 November 2026. They are not an India-wide rate card, an independently tested service offer or a VUKAR repair quotation.

Keep the workshop price separate from the site work

One provider's published Hyderabad workshop references
Motor rating Published workshop estimate Scope boundary
1–1.5 HP submersible motor ₹2,500–₹3,500 Extraction and borewell reinstallation excluded
2–3 HP submersible motor ₹3,500–₹5,000 Extraction and borewell reinstallation excluded
5 HP agricultural motor ₹6,000+ Confirm parts, tests and all site work in the written quote

The source is the provider's published rewinding-cost page. It describes a job including bearings and oil seals. Have the chosen repairer state exactly which items your price includes and confirm that the process suits your motor construction.

Confirm that the winding needs repair

A non-starting pump does not automatically need a rewind. Problems can be in the supply, starter, capacitor, cable, joint or mechanical load. Ask for the diagnosis and test findings before approving the winding work.

With a submersible system, a cable fault and a motor fault can lead to different repair decisions. Keep the motor and starter model numbers with the inspection report. Fault codes and current readings help the investigation but are not proof of winding damage by themselves.

Motor winding, a bearing and a workshop quotation
Ask the workshop to list winding work, separate parts and the test record in its quotation.

What changes the winding quotation?

HP is one input. Phase, speed, voltage, stator construction and motor type also matter. A surface motor, a sealed submersible motor and a specialised motor can need different materials, processes and tests.

Ask whether the price includes inspection, dismantling, winding work, insulation materials, impregnation or other treatment appropriate to the design, reassembly and final tests. Bearings, seals, shaft work or damaged laminations may require separate decisions. Obtain approval limits before extra parts are fitted.

Ask for records, not only a copper claim

A useful repair record identifies the motor and the work done. Ask what winding data is retained, what materials are used and what electrical and mechanical tests will be reported. The appropriate tests depend on the motor design and manufacturer's requirements.

EASA's Good Practice Guide covers repair processes and checking the completed repair for three-phase random-wound induction motors. It is a useful quality reference within that scope; a submersible motor also needs its own construction-specific requirements.

Compare the complete repair with an equivalent replacement

Add collection or transport, pump removal where required, workshop work, new parts, refitting, electrical correction and the final site test. Then compare with an equivalent replacement that can perform the same duty and fits the existing installation.

A simple “repair below half of new price” rule can miss access costs, remaining pump condition and repeat removal risk. Ask how the cause of failure will be addressed and what the written repair warranty covers.

What should the handover include?

Keep the invoice, motor identification, repair details and available test results. Once reinstalled, have running conditions checked and compare water delivery with the required duty. The starter and protection settings should be reviewed against the repaired motor and the manufacturer's instructions.

If the pump has been tripping, use the overload-setting guide as a discussion aid. A new starter cannot correct a damaged winding, and a rewind cannot correct a continuing supply or water-availability problem.

Sources and useful documents

Back to blog

Leave a comment

Please note, comments need to be approved before they are published.