Single Phase Openwell Automatic Starter Panel with Water Level Controller, Motor Safety, Cyclic Timer & MCB (OPA-H) VUKAR

Openwell Submersible Pump Starter Panel Supplier for Udaipur

Mohit Vekaria

For an openwell submersible pump starter panel in Udaipur, compare VUKAR OPA-H if the compatible single-phase pump fills a tank and your specification calls for float control and a built-in MCB.

Follow the pipe from the openwell

The state groundwater atlas maps wells and describes seasonal monitoring. The Dholi Magri project in Mavli documents a proposed openwell and pipeline. That combination is a reason to identify both ends of your own system. Start at the well and trace the pipe to the actual tank. Check whether a caretaker can see both points. If the person beside the panel cannot see the destination, ask how that person will recognise a full tank or a low source without guessing.

Udaipur groundwater atlas · Dholi Magri openwell project

Decide which condition the float reports

A full receiving tank and a falling well are different events. List each one as a separate stop condition and ask the installer how it will be verified. A float fitted to the receiving tank only reports that tank’s level.

Condition What to agree
Receiving tank full Ask the installer to demonstrate the stop
Source water low Record the separate response required at the well
Outside cabinet List mounting place and the field cable route

Before you order

Draw the water route before you label the signals. Mark the source, the pump, the receiving tank and any other inlet. On the drawing, put a mark where each level sensor is meant to act. Ask the installer to show what happens if water is low at the source while the receiving tank still needs water. Then ask to see what happens when the receiving tank is full. If another inlet can still fill the tank, give that inlet its own stop decision. This drawing also shows the supplier the cable route and which signals actually belong on the quotation.

Related guide · Water Pump Not Stopping When the Tank Is Full? Causes and Checks

VUKAR OPA-H product detail
VUKAR OPA-H product detail

Product and quote

For the quote, send the motor nameplate and show the pipe destination, float location and length of the route back to the panel. Ask whether the exact variant includes the float and what the installer will supply.

Take a readable photograph of the motor label and the outside of the old panel. Include the pump’s job and the settings or alarms that the operator can see. Ask the electrician to identify the starting method and write down the motor details the supplier needs. Keep each photo with the pump ID so it cannot be mixed with a spare or with a similar motor elsewhere on the site. If a label is illegible, ask for an assessment before choosing a variant. When the equipment arrives, compare its exact code against the approved quote before the installer starts work.

Compare the installed job, using the same scope for each seller. Ask for the exact model and variant, the included parts, the cost of field cable and any mounting work. Ask who supplies the sensors and who returns if a setting needs correction. A lower panel price can leave out the part of the job that brings the pump back into service. Write the test you expect alongside the price. That makes it clear whether one supplier has quoted equipment only and another has also included fitting, setting up the controls and demonstrating them to the person who operates the pump.

Ask for a quote

Back to blog