Single Phase Openwell Automatic Starter Panel with Water Level Controller, Motor Safety & Cyclic Timer (OPA-B) VUKAR

Openwell Submersible Pump Starter Panel Supplier for Mandya

Mohit Vekaria

For an openwell submersible pump starter panel in Mandya, compare VUKAR OPA-B when a compatible single-phase pump tops up a farm tank. Identify every inlet first, especially if canal water and the pump share a tank.

Mark both inlets on a Mandya farm

NABARD’s Mandya plan reports a mix of canal, tank and well irrigation. It also records delays in some tail-end areas, including Koppa Hobli. The first fact changes what belongs on your tank sketch. The second changes who decides when the well should top up. Ask the farmer who watches canal arrivals and who can authorise the pump to start when canal water is late. Write those roles beside the pipe names so the person buying the panel and the person running it use the same plan.

NABARD Mandya district plan · Mandya agriculture department

Who stops each inlet?

Suppose canal water and the openwell pump can both fill one tank. Mark one line as the gravity inlet and the other as the pump line. Ask how the gravity inlet is stopped when the tank fills. The pump’s starter only controls the motor connected to it.

Condition What to agree
Canal arrives Record who controls the gravity inlet
Well tops up Confirm the correct starter variant and float
Both inlets active Agree which inlet stops and who checks the other

Before you order

Draw the water route before you label the signals. Mark the source, the pump, the receiving tank and any other inlet. On the drawing, put a mark where each level sensor is meant to act. Ask the installer to show what happens if water is low at the source while the receiving tank still needs water. Then ask to see what happens when the receiving tank is full. If another inlet can still fill the tank, give that inlet its own stop decision. This drawing also shows the supplier the cable route and which signals actually belong on the quotation.

Related guide · Automatic Water Level Controllers for Tank Filling

VUKAR OPA-B product detail
VUKAR OPA-B product detail

Product and quote

Send the electrician a sketch of both inlets, one photo of the nameplate and the location of the float. Ask VUKAR to confirm the exact OPA-B variant and ask your installer to demonstrate the pump stopping at the selected full level.

Compare the installed job, using the same scope for each seller. Ask for the exact model and variant, the included parts, the cost of field cable and any mounting work. Ask who supplies the sensors and who returns if a setting needs correction. A lower panel price can leave out the part of the job that brings the pump back into service. Write the test you expect alongside the price. That makes it clear whether one supplier has quoted equipment only and another has also included fitting, setting up the controls and demonstrating them to the person who operates the pump.

Put a short operating card beside the pump log. Give the pump a name that matches its label on the drawing. Write the usual start condition, the normal stop and the name of the person who can approve a change. Leave room to record the time, the tank state and any alarm before someone clears it. During handover, have the regular operator explain the sequence back to the installer in their own words. If the two descriptions disagree, resolve that difference while the installer is still there. Keep the model number and the accepted test result with the card.

Ask for a quote

Back to blog