Illustration of an industrial water buffer tank and transfer pump in Tiruppur

Digital Auto Switch Supplier in Tiruppur

Mohit Vekaria

If you need a Digital Auto Switch Supplier in Tiruppur, SubmersibleShop.com offers the VUKAR DEV-P1 for a compatible three-phase pump starter. Consider it when the starter works and the pump needs to repeat a run and rest cycle. For a textile unit, this guide covers clean utility water held in a buffer tank. A buffer tank stores water before the next pump uses it. Decide how the pump will stop if that tank is low.

Three-phase pump auto switch for an existing starter

The New Tirupur Area Development Corporation project profile says its treatment and distribution system serves industries in and around Tiruppur. A factory with a connection still needs to identify where water enters its own system. In the example here, the incoming pipe fills a ground tank. A separate pump transfers that stored water to the point of use. Quote the control for the internal transfer pump. Write the tank and pump names on the drawing so the installer does not confuse it with another line.

If the existing starter is sound, a retrofit adds a function while keeping that starter. Have an electrician identify the old starter, its control voltage and its stop inputs. Ask whether the switch can control it in the way the site needs. If the old panel also needs replacement, ask for a complete starter quote. A new timer will not solve a fault in the power circuit. Record which part will stay and which part the supplier must replace.

Illustration showing the inlet, buffer tank, transfer pump and receiving tank
The incoming connection and the transfer pump are separate points. Label both when asking for a quote.

When a retrofit cyclic timer helps

A cyclic timer repeats an on period and an off period. It can suit a transfer task with a regular pattern. It cannot see how much water is in a tank. The DEV-P1 product page lists cyclic timing and motor protection for compatible three-phase applications. If the plant needs a start at set times of day, compare a clock timer. If water level decides when the pump stops, ask for the level control or safety input that will enforce that stop.

Worked example · Water moved in one run

Suppose a pump moves 40 litres per minute and runs for 6 minutes. It sends about 240 litres in that run if the rate stays steady. If the receiving tank has only 180 litres of free space, that cycle is too long unless a separate level stop acts first.

Need Control to compare
Repeat a run and rest Cyclic timer on a compatible starter
Run at fixed times Clock timer
Stop when the tank fills or the source falls low Level control or a suitable stop input

Keep the repeat cycle separate from a fault restart. A normal rest period is part of the chosen work pattern. A restart after the pump stops on a fault is a separate decision for the electrician and site operator. Write down whether someone must check the pump first. A test at handover should show what happens when power returns halfway through a rest period. Put the agreed behavior on the job sheet.

Clean-water buffer tank limits for the run plan

Use the site's measured pump flow to work out how much water leaves the tank in one run. The amount already in the tank and the water coming in during the run both matter. The receiving tank needs enough space for the transfer too. Keep dyeing process lines, wastewater and treatment equipment outside this simple example. For those jobs, let the site engineer define the fluid, control and protection. Record the free space in the receiving tank just before the first run of a shift. Check it again before the next run if the process did not draw the usual water. A short run can still be too long when the tank is nearly full. Put that case on the handover checklist.

What belongs in a Tiruppur auto switch quote

Send the motor nameplate, existing starter label and control voltage. Include the source tank, receiving point, normal run and rest times and low-water stop rule. Ask the supplier to specify whether the quote covers the switch alone, level controls, cable, fitting and tests. Give your delivery PIN code when asking for a dispatch estimate.

Compare the three-phase digital auto switch range, then send your pump and existing starter details to VUKAR. Ask for a quote that shows what the site keeps and which controls are added.

Back to blog