Automatic Water Level Controller Supplier in Sikar
Mohit VekariaShare
If you’re searching for an Automatic Water Level Controller Supplier in Sikar, SubmersibleShop.com offers VUKAR DEV-H2 for a compatible single-phase pump with cable floats in two tanks. If your old system uses metal probes and suddenly misses the stop level, ask for a probe check before buying. An installer can check for deposits, service the existing sensor if its maker allows, and test whether the level signal works again.
Sikar tank probe deposits and water hardness
The Sikar district environment plan flagged high hardness in groundwater. Hardness comes mainly from dissolved calcium and magnesium. Hard water can leave pale deposits on surfaces. If your tank uses groundwater, ask the installer to look at the actual sensor. The district report cannot tell you how hard your own tank water is or whether a deposit caused a fault. Sikar district environment plan
Find out what kind of sensor you have. A conductive probe is a metal part that senses water through a small electrical signal. A cable float has a moving body that changes the switch as the water level changes. Photos of the sensor and the controller model help the installer find the correct service instructions. Keep clear of the tank and wiring during the work.

Conductive probe cleaning and tests before replacement
Omron’s guide for its electrode level controls describes wiping lime deposits off its electrodes. Have the installer follow the instructions for your exact model. The cleaner and method must suit the sensor and the water use. Ask the installer to look for a damaged probe, loose wire or another cause before returning the system to use. Omron electrode level control guide
Worked example: test again after probe service
Suppose an old probe system misses the high stop on two of three test fills. The installer finds deposits and services the probe using its maker’s instructions. The high stop works on all three repeat fills. Keep that result with the service date. If the fault returns, ask the installer to check the probe, cable and controller again.
| What the installer sees | What to check next |
|---|---|
| Deposits on a compatible probe | Follow the maker’s service instructions and retest. |
| Probe signal still fails | Check the sensor, wiring and controller separately. |
| Moving to cable floats | Quote both sensors, fitting and stop tests. |
Ask for a controlled fill and drain test after the service. Compare the actual water level with what the controller shows at the start and stop points. Record each result. If the signal still fails, ask which part the installer has ruled out and which part needs a test. A second bad reading does not tell you on its own whether the probe, cable or controller is at fault.
Cable floats for a tank pair
DEV-H2 takes two float-switch inputs on a compatible single-phase openwell or monoblock pump circuit. A float needs room to move, and its wiring must match the controller. If you change from probes to floats, ask the installer to price and test the complete arrangement. The old probe wires and the new float switches need a proper compatibility check. Ask for a low-source stop and a full upper-tank stop. VUKAR DEV-H2 model and installation details
Sikar sensor replacement quote and handover
Send the motor label, controller model, sensor photos and a simple drawing of both tanks. Ask for the service result in writing. If an upgrade still makes sense, get the controller, sensors, fitting and tests on separate quote lines. Ask what routine check the new sensors will need and who will do it. Keep the answers with the dated test record.
Compare VUKAR single-phase water level controller models. Then send your sensor photos and motor details if the installer has found that a different control setup is needed.