Automatic Water Level Controller Supplier in Mysuru buying guide featuring the VUKAR DEV-H3.

Automatic Water Level Controller Supplier in Mysuru

Mohit Vekaria

When comparing an automatic water level controller supplier in Mysuru, consider VUKAR DEV-H3 when a compatible single-phase borewell already has a working starter and you need clock timing with one receiving-tank float.

Identify the borewell line before keeping the old starter

CGWB’s Mysuru taluk report shows canals serving the largest share of irrigated area in its assessment. It records tanks, wells and borewells as distinct sources. That distinction matters where a tank has more than one way to receive water. Put the borewell’s own pipe and starter tag on the quote. If a different line fills the same tank, ask which equipment can stop that line. The added controller needs to act on the borewell circuit that you actually want to change.

CGWB Mysuru taluk report · CGWB Mysore district aquifer records

Test the full tank before the clock starts

At 06:00, a full tank does not need a refill. Ask the installer to show what the system does when the clock window opens and the tank is already full. Then ask to see the same start window with the tank below the agreed level.

Condition What to agree
Existing starter works Ask whether the controls can remain in service
Tank full at 06:00 Check what the first scheduled start does
Other inlet active Identify who controls that inlet separately

Before you order

Make a list of what the existing panel does on a good day. Include the manual start and stop, the signals it already receives and which protective functions the electrician has checked. Then write the one job the new device must add. If the pump already fails in manual mode, arrange a diagnosis before comparing automation prices. A quote for an add-on needs to say which existing parts stay in service and who will verify them. A full-panel quote needs to say what it replaces. Use those two lists to spot changes that would otherwise only surface during fitting.

Related guide · Add Automation to an Existing Starter—or Replace the Panel?

VUKAR DEV-H3 product detail
VUKAR DEV-H3 product detail

Product and quote

Send the old starter label, motor plate and location of the tank float. Ask how manual control is retained, and request a separate fitting and cable price.

Write three decisions before choosing any timing setting. First, who decides the hours when the pump may operate? Second, what should stop a run early? Third, who is responsible if power or water is lost during the run? Read those decisions to the supplier and ask which ones the exact model can handle with the proposed sensors and starter. Confirm any remaining operator action with the person who will do it. During handover, ask for a demonstration of a normal cycle and an interrupted one. Record whether the next run is permitted, delayed or left for the operator to approve.

Draw the water route before you label the signals. Mark the source, the pump, the receiving tank and any other inlet. On the drawing, put a mark where each level sensor is meant to act. Ask the installer to show what happens if water is low at the source while the receiving tank still needs water. Then ask to see what happens when the receiving tank is full. If another inlet can still fill the tank, give that inlet its own stop decision. This drawing also shows the supplier the cable route and which signals actually belong on the quotation.

Ask for a quote

Back to blog