Hyderabad building showing a separate route from a ground sump to the roof tank

3 Phase DOL Starter Panel Supplier in Hyderabad

Mohit Vekaria

If you need a 3 Phase DOL Starter Panel Supplier in Hyderabad, select the pump for the building’s sump-to-roof job first. A sump is a low storage tank. Write the height and the amount of water the pump must deliver each minute. Then match the panel to the motor on the selected pump. DOL means direct on line. It starts a suitable motor by connecting it straight to the power supply.

Plan the Hyderabad sump-to-roof pump

Section 32 of the Hyderabad Metropolitan Water Supply and Sewerage Act places the Board connection at ground level and bars drawing water directly or indirectly from the mains or service pipes. It calls for a sump and pumping arrangement for premises with more than one storey connected at ground level. Show the incoming Board pipe, the sump and the separate roof-tank route on the building plan.

Ask the plumber to mark where the Board water enters the sump and where the transfer pump takes stored water. Write down how much water the roof tank needs in one refill. Divide that amount in litres by the minutes you can allow. This gives the target flow in litres per minute. The pump supplier needs this number and the lift. Tank size alone cannot tell the supplier which pump to offer. Write the normal and low working levels in the sump. If the roof has two tanks, mark which tank the pump must fill and whether both can take water at once.

Vertical rise from a sump water level to a roof tank with bends along the pipe
Measure the vertical rise and show the pipe route so the plumber can work out pipe losses.

Work out the roof tank pump head

Head describes the work the pump must do to move water, expressed in metres of water. First measure the vertical rise from the low working water level in the sump to the discharge point at the roof tank. Then show the plumber the pipe size, length, bends and valves. These add losses as water flows. Ask the plumber to calculate that extra head at the target flow.

Worked example · Check the pump at 22 metres

Assume the lift is 18 m and the plumber estimates 4 m of pipe losses at 50 litres per minute. The pump must deliver 50 litres per minute at 22 m of head. Those figures show the maths. Use measurements from your own building.

Ask for Why it matters
Target flow Water to move divided by the refill time
Head at target flow Vertical rise plus pipe losses
Selected motor plate Identifies the compatible starter variant

Ask the pump supplier for the pump curve, a chart showing the flow a pump can deliver at different heads. Point to the required flow and the estimated head together. Two pumps with the same motor HP can move different amounts at the same height. Ask for the offered model’s result at your duty point. That is the pair of numbers the pump must meet during the job. Use the actual planned pipe route for the estimate. A shorter line on paper can hide bends or a valve that the plumber will fit.

Confirm the three-phase DOL starter match

Once the pump is selected, check its motor plate and have an electrician confirm the supply and starting method. The VUKAR TPO-H listing is for compatible three-phase openwell and monoblock pumps. It lists water-level control and an MCB, a small circuit breaker. Ask how the controls will stop the pump at the low sump level and when the roof tank fills. Have the electrician check the site’s wiring and protection needs too.

What to send for a Hyderabad DOL starter quote

Send the selected pump model, the motor plate with voltage, phase, HP and rated current, the two tank levels and the PIN code. Ask for separate lines for the panel, level switches, cable, fitting and testing. Have the plumber prove the flow at the roof with the normal pipe route in use. Have the electrician prove both stops. Put the tested flow, motor model and stop levels on one handover sheet. If the pipe route changes during the job, ask the plumber to check the head and update the test sheet.

Compare the three-phase DOL starter options. Then send VUKAR the selected pump model and motor plate for a panel quote that matches the transfer job.

Back to blog