Several generic motor capacitor packages with distinct shapes

Capacitor Types: Uses, Differences and a Visual Selection Chart

Mohit Vekaria

Choose a capacitor by its job, voltage, capacitance and duty. Ceramic parts are common for high-frequency filtering, electrolytics for bulk DC energy storage, and film capacitors for many AC and pulse applications. For a single-phase pump, first check whether the motor needs a start capacitor or a run capacitor.

µFCapacitance. Match the motor maker’s value or approved range.
V AC or V DCVoltage rating and circuit type. Match the application.
DutyMotor start and motor run have different operating requirements.

Capacitor selection chart

Swipe the table sideways to see more columns.

Common capacitor types and where they are used
Type Typical use What to check
Ceramic High-frequency bypass and signal filtering. Voltage and capacitance change under DC bias for some dielectrics.
Aluminium electrolytic Bulk smoothing on DC power supplies. Polarity, temperature, ripple current and voltage.
Film Timing, pulses, AC applications and motor run designs. Select a film capacitor rated for the specific use and waveform.
Tantalum or polymer Compact DC filtering where the design calls for low impedance. Polarity, surge limits and voltage margin.
Motor start capacitor Short boost to starting torque in motors designed for it. Specified start duty, capacitance and AC voltage.
Motor run capacitor Continuous operation in compatible single-phase motors. Specified run duty, capacitance and AC voltage.

KEMET capacitor families and applications · KEMET example of a motor-run film capacitor

Three illustrative motor capacitor packages in different shapes
Check the specified capacitor type and rating. The case shape alone cannot identify the right replacement.

How to match a pump capacitor

Illustrative motor-run label

25 µF • 450 V AC • Motor run

For this example, use the motor manufacturer’s approved 25 µF motor-run replacement with the specified AC rating and compatible mounting. The same µF value on a DC or intermittent-duty capacitor is insufficient to establish compatibility.

  1. Read the motor data. Use the motor wiring diagram or manufacturer’s parts list to identify whether the circuit uses a start capacitor, a run capacitor or both.
  2. Read the capacitor label. Record µF, AC voltage, frequency and duty markings. Take a photo of the terminals and housing for the installer.
  3. Check fit and suitability. Match the manufacturer-approved electrical specification. Confirm dimensions, terminals and mounting. A technician should isolate the circuit, verify it is de-energised and safely discharge the capacitor before handling it.

What if the motor only hums?

Turn it off if it fails to start. A weak capacitor is one possible cause. A jammed pump, low supply voltage, a faulty start switch or damaged windings can give a similar symptom. Have the capacitor and the rest of the start circuit checked before buying parts.

Single-phase motor windings and capacitor guide

Quick answers

Can I choose a capacitor from HP alone?

No. Motors with the same HP can use different winding designs and capacitor values. Check the motor label, diagram or parts list.

Can I leave a start capacitor in the circuit while the motor runs?

A start capacitor is designed for short duty. In a circuit designed for one, the motor’s start mechanism takes it out of circuit after startup.

For pump starter options by motor size and control task, see the starter panel selection chart.

Back to blog

Leave a comment

Please note, comments need to be approved before they are published.