Industrial electric motor with its shaft visible and terminal box closed

Three-Phase Induction Motor: Working, Parts and Starting Methods

Mohit Vekaria

A three-phase induction motor uses a rotating magnetic field to turn its shaft. The three-phase supply produces that field in the stator. The field induces current in the rotor and creates torque. For a pump, choose the starting method using the motor nameplate, supply limits and starting torque the load needs.

StatorStationary windings create a rotating magnetic field.
RotorInduced current produces torque in the rotating part.
SlipThe difference between field speed and rotor speed, expressed as a percentage of field speed.
Separate stator, rotor and shaft of an induction motor
The rotating field in the stator induces current in the rotor and creates torque.

How the rotor starts turning

  1. Supply energises the stator. Currents in the three windings create a field that rotates around the motor.
  2. The field induces rotor current. Relative motion between the field and rotor induces current in the rotor bars of a squirrel-cage motor.
  3. Torque turns the shaft. The rotor accelerates until motor torque balances the load and losses. During normal motoring it runs below synchronous speed.

The bearings support the rotor and shaft. The shaft transfers torque to the pump or machine. The frame, cooling arrangement and motor enclosure depend on the application.

Nidec’s induction motor working principle

Calculate motor slip from nameplate RPM

Synchronous speed in RPM = 120 × supply frequency in Hz ÷ number of poles. Subtract the rotor speed and divide by synchronous speed to calculate slip.

Four poles on a 50 Hz supply

Field speed = 1,500 RPM • Rotor speed = 1,440 RPM

Slip = (1,500 − 1,440) ÷ 1,500 × 100 = 4%. This example uses rated speed. A measured speed should be compared under a known frequency and load.

Which starting method should you use?

Swipe the table sideways to see more columns.

Three-phase induction motor starting methods
Method When to consider it What to check
DOL The supply and load can accept a direct start. Starting current, voltage drop and mechanical shock.
Star-delta Reduced starting torque is enough for the load. Six accessible winding ends and a delta rating that matches the supply voltage.
Soft starter A controlled start or stop suits a pump or conveyor. Motor current, start time and load torque.
VFD The process needs adjustable running speed. Motor and drive compatibility, cooling and protection.

A 415 V supply requires a motor rated to run in delta at 415 V for a conventional star-delta starter. Have the installer confirm the nameplate, terminal access and load torque before selecting the panel.

Star-delta starter selection guide

What to send before ordering a starter

Share a readable nameplate photo, the available supply voltage and frequency, the pump or machine type, and how often it starts. Mention if the supply dips during startup or if the load needs speed control. That information makes the starting method and protection easier to size.

Quick answers

Why does a 1,500 RPM motor show 1,440 RPM on the plate?

The 1,500 RPM figure is the rotating field speed for a four-pole 50 Hz motor. The 1,440 RPM figure can be its rated shaft speed under load.

What if a three-phase motor loses one supply phase?

Single phasing can stop a motor from starting or cause damaging current in the remaining phases. Isolate the machine and have the supply and protection checked.

Compare starter sizes and control options in the motor HP and starter panel guide.

Back to blog