Illustration of a landscape tank and transfer pump beside a garden path

Water Pump Timer Switch Supplier in Pune

Mohit Vekaria

If you need a Water Pump Timer Switch Supplier in Pune, compare VUKAR DEV-K3 for a compatible single-phase starter on a garden tank refill pump. Pick a start time when the caretaker can check the water route and confirm that the tank needs a refill. A clock can request a start at a set hour. Water source approval and a full-tank stop are separate parts of the setup.

Choose which pump needs a landscape pump timer

The Pune Municipal Corporation Smart City proposal discussed using treated water for park irrigation. It describes a plan, so it does not establish the supply at your garden. Where a site already has a separate water line approved for landscape use, mark that line and its storage tank on the work order. Mark the drinking-water system separately. Ask the site operator to identify the pump that refills the landscape tank before a supplier quotes a timer.

Some sites have one pump that refills the tank and another that waters the garden. A gardener may want the transfer pump to run before the garden opens, then water different parts later. Those are two jobs. Label each pump and check which one the existing starter controls. The name of the valve or pipe beside the starter helps the next person identify the same equipment.

Drawing of two water tanks with a transfer pump, clock and separate level signal
The green route shows water transfer. The dashed line shows the level stop signal, separate from the clock.

When a single-phase water pump clock timer fits

The VUKAR DEV-K3 listing shows clock and cyclic timers for a compatible single-phase starter. Clock timing can set a daily refill hour. A cyclic timer repeats an on period and an off period. Ask the electrician to compare the device with the motor label and existing starter. The quote should explain what happens if the caretaker pauses a run and then hands over to another person.

Worked example · Refill before a site task

Suppose the caretaker can watch the pump from 06:30 to 06:50. At a steady 25 litres per minute, 400 litres take about 16 minutes. If only 250 litres of room remain, the tank can fill in about 10 minutes. In that case the level stop should act before the 20-minute window closes.

Situation What to put in the quote
Refill before a staffed task Specify the clock window
Tank fills early Keep a separate level stop
Approved source is unavailable Write the site’s stop rule

Write the latest acceptable stop time on the work order. The garden manager may need the pump to finish before a site task starts, such as an inspection or cleaning. If the refill cannot finish in time at the observed flow, adjust the work plan with the manager. A longer timer setting does not create more space in the tank. Use the worked example to make both limits visible.

Keep separate garden tank controls in the quote

A clock reads time. A level switch senses the water in a tank. If the receiving tank fills before the planned stop, a suitable level stop should end the run. Ask for the source-low and full-tank decisions in writing. If the site has an approval signal that prevents use of an unsuitable source, ask the electrician to keep it in the control plan. Test all required stops before the first unattended run.

What to send for a Pune pump timer quote

Send the pump label, starter model, tank drawing and the caretaker’s hours. Include the planned refill time and the rules for a full tank, low source, power return and a cancelled run. Ask the supplier to name the exact switch, any additional level control and the tests included. Put the operator’s stop rule in the handover note so the next shift knows what to do.

Open the single-phase digital auto switch comparison, then send the tank drawing and starter label to VUKAR. Ask which parts of your work order the proposed timer can handle.

Back to blog