Illustration of a farm tank and borewell pump controller in Kolar

Borewell Starter Panel Supplier in Kolar

Mohit Vekaria

If you need a Borewell Starter Panel Supplier in Kolar, SubmersibleShop.com offers the VUKAR TPB-T for compatible three-phase borewell pumps. It is worth comparing when a farm fills a tank in a set time window and needs the pump to stop if the tank fills early. Decide when the pump may run and how much room is available in the tank. Those two facts guide the quote.

Three-phase borewell starter for a farm tank

The Kolar district economy profile says farmers in the district depend on borewells for irrigation and drinking water. The Ministry of Jal Shakti's 2025 update lists Kolar among Karnataka's over-exploited groundwater districts. The district figures do not tell you how your well behaves. For a tank refill, record the actual flow and water needed. A fixed clock time cannot make a borewell deliver a set number of litres if its flow changes.

On a simple drawing, show the borewell, the tank that receives its water and the next place the water goes. The starter in this example serves only the borewell pump. If the farm also has a second pump that takes water out of the tank for irrigation, put it on a separate line. That keeps the quote from treating the borewell and field pump as one unit.

Diagram of a borewell filling a farm tank with a clock and receiving tank float
The clock controls when the pump may run. The receiving tank float provides a separate full-tank signal.

When a tank level and clock starter helps

The TPB-T product page lists a single cable float, automatic tank level control and clock and cyclic timers for compatible three-phase borewell pumps, with choices up to 10 HP. A float is a switch that moves with the water. The clock sets the allowed hours. The float tells the control when the receiving tank is full. Ask the electrician to show that the level stop works even when the clock window is still open.

Worked example · A half-hour window

Suppose the flow is steady at 20 litres per minute. Moving 600 litres takes 30 minutes. If only 400 litres of space remain, the tank reaches full in about 20 minutes. The level stop should act then. These numbers are examples, not a setting for your well.

Condition Requested behavior
Window open and tank needs water Pump can run if the source and installation allow
Tank fills early Float stops the pump before the window ends
Power returns after the window Check that the pump follows the agreed restart rule

Also agree what should happen if the electricity returns after the refill window closes. Ask the electrician to test that case along with a normal start and a full tank. If the farm needs only a tank level stop and pumping is allowed at any time, compare a simpler panel. If it needs two independent tank signals or another interlock, tell the supplier before ordering this single-float model.

Set a farm tank refill window using real readings

Record the free space in the tank before a run and measure flow at the outlet used to fill it. Divide the litres needed by the litres per minute when flow is steady. Use that time to compare the proposed window. Leave room for changes in flow and use the level stop. Avoid copying a neighbour's run time. The two wells, pumps and pipes may deliver different amounts. Keep a short log for a few normal fills. Write the tank level at the start, when the float stops the pump and whether the field pump was running. If the tank is already partly full after rain or a previous run, the borewell should stop sooner. If the time ends before the tank fills, check the actual flow and demand before asking the installer to extend the window.

What to send for a Kolar borewell panel quote

Send the motor plate, the current starter label, the pump's starting method and a drawing of the tank. Add the tank space, measured flow, refill hours and the required stop and restart behavior. Ask who supplies the float and cable and who checks the timing at installation. Include the delivery PIN code when you ask when the order can be sent.

See the three-phase starter panel comparison, then send VUKAR your motor plate and tank details. Ask for the exact variant and keep the agreed test cases with the work order.

Back to blog