Illustration of a tanker beside a building with permanent lower and roof storage tanks

Automatic Water Level Controller Supplier in Rajpura

Mohit Vekaria

If you need an Automatic Water Level Controller Supplier in Rajpura, SubmersibleShop.com offers VUKAR DEV-H2 for a compatible single-phase pump that moves water from a permanent lower tank to an upper tank. Approved tanker water delivered into that lower tank can use the same transfer route. If the delivery fills the upper tank directly or goes into separate temporary storage, first check whether the building's transfer pump has any role in that delivery.

Rajpura tanker water delivery and your tank

A Punjab government filing with the National Green Tribunal recorded interim drinking-water tanker supply for affected areas of Rajpura during work on the piped system. It also reported replacement of damaged lines and household connections in areas including Vikas Nagar and parts of Navyug Colony. Use that record to understand why a building might need a temporary delivery route. Check your current arrangements with the water service. Punjab government filing on Rajpura water supply

Draw the delivery path from the vehicle to the tank that gets filled. On the same sketch, draw the path from the fixed building pump to the roof tank. Keep approved drinking-water arrangements separate from other water systems. A licensed plumber can check the right fill arrangement and how to prevent water from going back into the wrong pipe. The National Building Code defines backflow and the open gap used in some water supply designs. National Building Code water supply terms

Three separate delivery destinations: permanent lower tank, upper tank and stand-alone temporary tank
Left to right: a lower tank served by the building pump, a direct upper fill and a separate temporary tank.

Permanent or temporary storage and the pump route

If an approved delivery enters the same permanent lower tank that normally holds water for the roof, the tank pair and transfer pump may stay the same. In that case, the controller responds to water level. It does not need to know whether the lower tank filled from an approved delivery or the regular inlet. Confirm the existing installation and permitted fill route with your plumber.

Worked example: one delivery, two possible routes

Assume an approved delivery leaves 600 L in your permanent lower tank. If the roof tank has room, a compatible pump can transfer water subject to its float settings. If all 600 L instead go to a separate temporary tank, the permanent lower tank has gained 0 L. The permanent transfer controller still sees a low source.

Delivery destination What the building pump does
Permanent lower tank Can move stored water if both levels allow it.
Upper tank directly Bypassed by the delivery.
Separate temporary tank Stays stopped if its own source is low.

If an approved delivery fills the upper tank directly, its filling bypasses the building pump. Its overflow is a separate plumbing concern. If delivery goes into a stand-alone temporary tank, leave that route separate unless the utility and plumber approve a connection. Check that the normal transfer pump stays stopped when its own lower tank is empty. Water in the temporary tank does not make water available at the pump's inlet.

Two-float pump control for a fixed tank pair

A float is a switch that moves with the water level. DEV-H2 has two float inputs for compatible single-phase openwell or monoblock pumps. Ask the electrician to test a stop for a low lower tank and a stop for a full upper tank. The controller operates your pump. For any delivery that fills a tank directly, agree with the supplier or installer who will watch the fill and who will close the inlet. VUKAR DEV-H2 product and installation details

Rajpura controller quote for the lasting setup

Send a photo of the motor plate, your sketch, tank capacities, and the starter details. Label which route you expect to use after pipe service returns to normal. Ask the electrician to price permanent pump automation separately from any approved temporary delivery work. Before handover, have the electrician confirm both float stops while the temporary inlet is out of use.

Compare the VUKAR single-phase water level controller models. Then send your two water paths and motor details so the supplier can check whether the permanent pump fits DEV-H2.

Back to blog