Workshop water connection, storage tank and three-phase transfer pump starter

3 Phase DOL Starter Panel Supplier in Ludhiana

Mohit Vekaria

If you need a 3 Phase DOL Starter Panel Supplier in Ludhiana, compare VUKAR TPM-A for a compatible three-phase workshop transfer pump. DOL means direct-on-line, where the starter applies full supply voltage when the motor starts. If the workshop has changed where its water comes from, check which pump actually needs a new starter. The incoming connection and the pump that moves stored water inside the building are two different parts of the job.

Trace the Ludhiana workshop water inlet

The Ludhiana Bulk Water Supply Project assessment identifies the 1R Canal as the proposed source for the city project. The Punjab estate management portal also handles water and sewerage billing for PSIEC Industrial Focal Point allottees. Neither record tells you which inlet serves your plot today. Mark the connection you use now on your workshop drawing. Then mark where it enters your first tank and where your own pump takes over.

For example, the workshop may have stopped using an old source pump after adding a new inlet. The transfer pump may still move water from the first tank to a tank by the work area. Tag those two jobs separately. If the old panel belongs to the pump no longer used, buying the same panel would leave the active transfer job untouched. Ask the electrician to match the tag on the panel to the motor that is still in use.

Diagram separating a workshop inlet from its internal tank transfer pump
The inlet fills the first tank. The starter in this guide controls the separate transfer pump.

Choose a DOL transfer pump starter for the active motor

The VUKAR TPM-A product page lists DOL starting, an auto switch, a cyclic timer and motor protection for compatible three-phase borewell, openwell or monoblock pumps. A cyclic timer repeats an on period and an off period. The model has variants up to 10 HP. Send a clear motor label photo showing phase, voltage, HP and current. Also send the old starter label. If the active pump uses a drive or star-delta starting, ask the electrician to assess that arrangement separately before placing an order.

Worked example · Check two tank marks

Suppose two marks on the tank are 240 litres apart. It takes 8 minutes to fill between them, so the measured rate is 30 litres per minute. If the same test takes 12 minutes after a pipe change, the rate is 20 litres per minute. Those sample readings tell the installer what changed. They do not set motor protection.

What you observe What to do first
First tank has no water Check the inlet before ordering a starter
Pump runs but the tank fills slowly Record the flow and ask the installer to find the cause
Pump does not respond to its usual start request Record the panel indication and ask the electrician to trace the fault

Write down which signal allows the pump to run and which signal must stop it. For example, the old control might stop when its receiving tank is full. The timer cannot measure how much water is in a tank. If that level stop is required, ask the installer to identify the separate switch and show that the new arrangement still responds to it. Ask for the required breaker, overload protection and installation scope in writing.

Use a tank fill rate test after plumbing changes

Use two marks that represent a known volume in the receiving tank. Ask the installer to measure the time between them during a normal fill, with other draws from that tank turned off. Divide the litres added by the minutes taken. If the tank fills more slowly after pipe work, record the new time and the motor reading before changing any settings. Less flow can come from the pipe, the tank level or the pump. A starter replacement alone does not establish the cause.

What belongs in a Ludhiana starter panel quote?

Send the inlet and tank drawing, the pump tag, both label photos and the observed fill time. Add the expected start and stop signals. Ask the supplier to name the exact TPM-A variant if it fits. Have the installer test a normal run and the agreed stop signal. Record what should happen if power returns with the pump request still active. Include your delivery PIN code when asking for dispatch.

See the three-phase starter panel comparison, then send the active pump label and tank sketch to VUKAR. Ask for the parts, fitting and on-site tests as separate lines in the quote.

Back to blog