3 Phase Borewell Starter Panel Supplier for Deesa
Mohit VekariaShare
Picture the call at the end of the day. The pump ran, but the farm tank is still half empty. Was the well giving less water, or did the starter stop the motor? If your Deesa farm uses a compatible three-phase borewell pump to fill a tank, ask VUKAR for a quote for the TPA-B three-phase borewell starter panel from Rajkot. Take a photo of the motor plate and explain where the water goes before ordering.
Why the pump and the tank are two separate checks
The Central Ground Water Board’s Deesa taluka study identifies tube wells and borewells as the main irrigation source in its 2022 data. Its monitoring records also show that water levels vary across observation dates. For a farm purchase, that means recording what your well actually delivers while running. A reading from a nearby well gives context. Your own pump test gives the figure you can plan with.
CGWB Deesa taluka study · Gujarat Deesa groundwater profile
Which panel fits your job?
TPA-B combines a three-phase direct-on-line starter, an automatic tank-level input and a cyclic timer. Direct-on-line, or DOL, is a way of starting a motor. VUKAR lists TPA-B variants up to 10 HP. Ask your electrician to match the exact variant to the motor nameplate and existing starting arrangement. The supplied cable float monitors the receiving tank. Ask the electrician to set and check dry-run protection separately for the pump.
| Farm layout | What to compare |
|---|---|
| Borewell fills a storage tank | Match the TPA-B variant and included tank float to the motor and tank. |
| Borewell feeds the irrigation line directly | Ask for motor protection and the required operating timer. Tank-level control is useful when there is a tank to sense. |
| Existing starter works but the well output falls | Ask the installer to measure output and review dry-run settings before buying another panel. |

Work out the refill from actual flow
Say you need 3,000 L in the storage tank for the next irrigation run. If you measure 60 L/min at the inlet, filling takes about 50 minutes. At 40 L/min, the same refill takes about 75 minutes. These are illustrative numbers. If the flow falls after the first few minutes, write down both readings. Then ask the installer to check the well and motor before using either reading to set a repeat timer.
Put these details in the Deesa quote
Send the motor plate photo, old starter photo and delivery PIN code. Tell us whether the borewell feeds a tank or the irrigation line directly. For a tank, ask what float and cable come with the chosen variant, what extra cable or enclosure work the site needs, and what the installer charges. Ask for hardware, fitting and dispatch separately.
What to check at handover
Ask the electrician to demonstrate that the tank-full signal stops the pump. Review the displayed fault and the approved reset steps with whoever runs the pump. Keep the variant, motor plate photo and recorded settings with the receipt. A second person can then describe the same problem if support is needed during the next irrigation run.