Water Pump Timer Switch Supplier in Nagpur
Mohit VekariaShare
Need a Water Pump Timer Switch Supplier in Nagpur? Compare VUKAR DEV-K3 if you have a compatible single-phase nursery pump starter and need fixed watering times. If one pump serves two groups of young citrus plants, choose each group’s run time with the grower and make a plan for changing valves. The pump timer can start the pump. The valves decide where the water goes.
Plan Nagpur citrus nursery watering by plant group
The Nagpur district’s One District One Product page names oranges as a district product. The Indian Council of Agricultural Research announcement records that its Nagpur citrus institute licensed a container nursery method to a nursery in Katol taluka. In a container nursery, young plants grow in trays, bags or pots. When they move into a different container or to another bench, check whether the grower wants a different watering run before you put them on the same timer.
Draw each group of containers and the pipe that waters it. A zone is a group that shares a water line and valve. Ask the grower whether young plants in trays and older plants in bags can use one run. If the groups need different watering, mark both valves and give each group a time. The grower should set the times for the plants, containers and conditions at that site. Put the same zone name on the valve and on the bench. During the first run, have a worker check which bench gets water. If the bench and valve labels disagree, correct them before using the timer.

Leave time for the nursery pump valve change
For valves turned by hand, name who will change them and check the open route before a start. Agree when the pump should remain stopped if the worker is late or away. In the sample, the first run ends at 08:08 and the second starts at 08:12. Those four minutes are for checking the next route with the pump stopped. Before you choose a gap, watch how long the actual change takes.
Worked example · Water one group at a time
Suppose the grower chooses 8 minutes for trays and 12 minutes for bags. Run the trays from 08:00 to 08:08. Check the next valve with the pump stopped. Run the bags from 08:12 to 08:24 after the route is ready. These times show the valve change, and each nursery sets its own durations.
| Nursery setup | What to compare |
|---|---|
| One group with an open water route | Pump clock timer for a fixed run |
| Two groups with valves turned by hand | Separate runs and a worker to change the valve |
| Two groups with no worker present | Coordinated valve and pump control |
If staff cannot be there each time, ask an irrigation installer about a valve controller that coordinates the pump and valves. Ask them to demonstrate what happens when a valve fails to open. If a valve is already controlled by another box, show the installer that box too. Have them check how the pump will avoid starting with no open path. Keep the approved protection in place.
Check the single-phase nursery pump timer
The VUKAR DEV-K3 product page lists a clock timer and a 1–35 A range for single-phase applications. A clock timer gives start and stop requests at set times. Have an electrician match the starter and current to the motor label. Ask them to show how the pump behaves if electricity returns during the valve change. The operator should know how to check the valve before the next run or hold the schedule if the route is uncertain.
What to send for a Nagpur pump timer quote
Send the motor plate, starter label, zone sketch and each proposed run. Mark which valves are manual and which are powered. Include how long it takes to move from one group to the next and who will be there. Ask for the switch, fitting and any separate valve control to be priced separately. Add your delivery PIN code when asking about dispatch.
Read the single-phase digital auto switch comparison, then send VUKAR the starter details and zone sketch before ordering.