Water Pump Timer Switch Supplier in Kheda
Mohit VekariaShare
Need a Water Pump Timer Switch Supplier in Kheda? Compare VUKAR DEV-K3 for a compatible single-phase pump that runs dairy-shed sprinklers in short bursts. Before ordering, check that the animals can drink when that pump is stopped. Also check who will watch the fans and spray. Ask your dairy adviser to help choose a cooling routine for your shed.
Check the Kheda dairy shed sprinkler
The Kheda district administration describes dairy farming as part of the local Amul cooperative network. The National Dairy Development Board handbook discusses the use of small pumps and repeating timers for sprinklers. It also calls for shade, drinking water and more air movement in covered sheds. A sprinkler sends water out in a spray. The pump moves water to it and the fan moves air. Give each part its own check before you set the run times.
Watch one run with the shed worker. See where the spray lands and where water collects on the floor. Check that the fan is working and the line sprays as expected. Tell the installer if a nozzle starts slowly or a spray outlet is blocked. Ask who will stop the sprinkler and contact the dairy adviser if the setup stops working as planned. Keep a sheet by the controls. Write down when the run starts, when it stops and whether the fan and trough worked. If the shed gets hotter or the air is very damp, ask the adviser whether to change the plan. A timer counts minutes, so staff still need to check the shed and its animals.

Keep a separate cattle drinking-water supply
Draw the line from the pump to the sprinklers. Then draw the line that fills the drinking trough, where animals drink. If both lines rely on the same pump, ask how the trough will still get clean water when the timer stops the spray. Have the installer show how the two jobs can work independently. Run a test with the sprinkler off and check that the normal drinking supply still works.
Worked example · Count the spray water for one hour
Suppose your adviser approves a trial of 2 minutes on and 18 minutes off. That gives 3 runs in one hour. If the spray uses 4 litres a minute, it uses 24 litres in that hour. This is sample spray use. Count the drinking water separately.
| What you find | What to check |
|---|---|
| Trough needs the same timed pump | Show how drinking water stays available when spray stops |
| Fan fails or spray lands in the wrong place | Pause the spray and have staff check the setup |
| Pump and spray work during the trial | Record the settings and confirm the drinking supply |
If both lines draw from one tank, find out how much water the spray will use and what happens if the tank level falls. Ask the installer to show the low-water stop for the sprinkler and how drinking water remains available. Keep the trough and sprinkler labels easy to read. The next worker should be able to tell which switch controls each job.
Choose a single-phase cyclic pump timer
The VUKAR DEV-K3 product page lists a cyclic timer and a 1–35 A range for single-phase applications. A cyclic timer repeats a run and a pause. Ask the electrician to match the pump and starter to the product and check the pump maker’s limit on starts. The times in the example are for working out water use. Use the actual spray flow and cooling plan from your own shed.
What to send for a Kheda pump timer quote
Send the motor and starter labels, your planned run and pause, and a drawing of both water lines. State how the fan is controlled and who can stop the sprinkler. Ask what the switch will do when power comes back and how staff can check the first run. Ask for separate prices for the switch, fitting and any extra water control. Give your delivery PIN code.
Read the guide to pump timer types. Then send the shed plan and starter details to VUKAR for a fit check.