Nagpur mandarin orchard with a main irrigation pump and a separate fertilizer feed

3 Phase DOL Starter Panel Supplier in Nagpur

Mohit Vekaria

If you need a 3 Phase DOL Starter Panel Supplier in Nagpur for an orange orchard, quote the main water pump and the fertilizer injector as separate jobs. DOL means direct on line. It starts a suitable motor by connecting it directly to power. Ask the installer to show how fertilizer feed will stop if the water pump stops. A normal pump starter protects the motor, while the orchard needs a separate decision about the injector.

Plan Nagpur mandarin fertigation around the water pump

Scientists at ICAR’s Central Citrus Research Institute in Nagpur discuss feeding Nagpur mandarin trees through irrigation. Fertigation means adding fertilizer to irrigation water. It changes the control job. Water must be flowing for the fertilizer to move through the lines. Mark the main pump, the injector and the point where they meet on a simple farm sketch.

Write who checks water flow before the injector starts and who stops the fertilizer before the final clear-water run. During normal operation the clear-water run helps clear the lines before the water pump stops. Your irrigation adviser should set the run steps for your farm. Give the panel supplier the sequence, even if one worker currently handles every step. Give the water pump and injector different names on the sketch and test sheet. If a farm has two blocks, mark which block will be open during the test.

A normal irrigation route and a stopped fertilizer feed after a water pump stop
The irrigation installer should show that a stop at the water pump also stops fertilizer feed.

Put the fertilizer injector stop on the job sheet

An interlock is a control that makes one device depend on another. Virginia Tech’s micro-irrigation guidance describes an interlock to prevent an injector running unless the irrigation pump operates. It also describes preventing backflow, where liquid travels in the wrong direction towards the water source. Ask the installer to specify both protections for the site, including how the injection feed responds to lost water flow.

Worked example · The water pump stops first

Suppose the water pump trips during an injection run. The injector should stop with it. When the water fault clears, check the agreed restart steps before starting another injection run. Do not assume the unfinished run should simply continue.

Stage What to prove
Water start Establish water flow before feeding fertilizer
Water pump stops Stop the injector through the agreed protection
Normal finish Stop fertilizer feed and clear the line before water stops

Ask for a clear test using a safe method agreed with the irrigation installer. The test should show the normal start, the response to a water-pump stop and the conditions for restarting the injector. Ask who can clear a fault and resume a stopped run. If the water pump restarts after a power cut, the installer should show how the agreed injection controls behave then as well.

Match the three-phase irrigation pump starter

The VUKAR TPM-H product page lists a DOL starter for suitable three-phase borewell, openwell and monoblock pumps up to 10 HP. It lists motor protection, a fault display and a built-in MCB, a small circuit breaker. Use the motor plate to choose the variant. Ask for the injector and any required flow signal, interlock or extra controls to be listed separately. Ask the electrician to confirm the starting method and whether a timer fits the agreed water run.

What to send for a Nagpur DOL starter quote

Send the water pump motor plate showing phase, voltage, HP and rated current. Add the injector type, the sketch, the test you expect and your delivery PIN code. Ask which controls come in the panel and which the installer must add. Put the name of the person who checks the water flow on the handover sheet. Keep a copy at the pump so another worker can follow the same steps. If the installer changes the control after testing, ask them to update the sketch and repeat the pump-stop check.

Compare the three-phase DOL starter options, then send VUKAR your motor label and irrigation sketch. Ask for the main pump starter and list any separate injection control needed.

Back to blog