10,000 Litre Water Tank Prices for Buildings and Factories
Mohit Vekariaशेयर करना
A 10,000 L black Sintex CCWS-1000.02 was listed at ₹90,002 including tax on 10 November 2026, with availability on request. Price the complete facility job, including freight, unloading, foundation, valves and commissioning. The published listing gives conflicting dimensions, so use the manufacturer’s exact drawing before placing the order.
Plan for ten tonnes of water and the route in
- ₹90,002Listed tank price including tax.
- 2.51 m × 2.44 mApproximate dimensions from the specification table. Confirm against the exact drawing.
- About 10 tonnesWater alone at nominal capacity. Plan for support and site access.
The retailer’s product text and specification table give different dimensions. Use the exact manufacturer drawing for the order and ask the supplier to confirm it in writing. A small error in width can affect vehicle access, the route from the gate or where the final base goes.
Plan a delivery that fits the site
Picture a factory with a wide gate and a narrow turn between the boundary wall and a shed. The delivery vehicle reaches the gate easily. The hard part is moving the tank from the truck to the base without closing a busy route. Have the vendor and the installation team agree on vehicle access, unloading equipment, safe clearances and the delivery window.
In a residential building, agree who can keep the service lane clear and how water will be available if the old tank comes out first. At both sites, get written responsibility for unloading and for damage found when the tank arrives.
Separate staff, washdown and process demand
For an apartment, count water used in the longest planned gap between refills. For a factory, separate staff use, routine cleaning and process water where they have different demand or water-quality requirements. Fire water and other regulated systems need separate design and approvals appropriate to the site.
A source that supplies 80 L per minute would take 125 minutes to fill an empty 10,000 L tank if no water leaves during the fill. A two-hour window would supply about 9,600 L at that flow. Check your actual normal refill volume with the tank calculator before choosing the nominal capacity.
Put the refill window against the shift demand
If a site uses 6,000 L during one shift and can refill for 60 minutes at 80 L per minute, only 4,800 L comes back. The next shift starts 1,200 L lower under those assumptions. Measure actual inflow and draw. If one tank is taken out for cleaning, check which users can keep running before deciding on a single tank or a split arrangement.
Make the cost comparison useful
Get the tank, freight, unloading, support or foundation, fittings, valves, plumbing and commissioning priced separately. Include the drain, safe overflow discharge and cleaning access. Have a qualified professional assess the full installed load and the proposed foundation or building support. Water alone weighs about ten tonnes at nominal capacity.
Give the operator a handover sheet
Record the exact tank model, normal refill time, valve positions and the contact for warranty or service. Ask the installer to demonstrate the drain and isolation steps with the operator present. If you use the tank as a process buffer, note the level at which production should switch to backup supply or pause.
Record the normal refill time, which valves isolate each line, where overflow discharges and the service contact. Ask the installer to demonstrate those points before handover.
Compare one 10,000 L tank with a split arrangement if supply continuity matters. Ask the plumbing designer what can stay in use during cleaning and what changes in valves and controls. Record the answer beside each quote so the maintenance trade-off is visible before purchase.