Closed overhead tank on a flat concrete platform on a terrace.

Water Tank Stands and Platform Choices

Mohit Vekaria

Choose a water tank stand or platform from the exact tank footprint and full load. A 500 L tank holds about 500 kg of water. A 1,000 L tank holds about 1,000 kg. The support also carries the tank and fittings. For a rooftop or raised installation, have the support assessed before ordering.

Tank support and access

Start with full weight and the reason for raising it

  • Ground-level platformUse when no extra gravity height is needed. Match the manufacturer’s support details.
  • Low raised baseUseful for some pipe routes. Leave room to service the outlet.
  • Elevated standUse a site-specific design, with safe access and confirmed load transfer.

Start with the load and the reason for raising it

A full 500 L tank holds about 500 kg of water. A full 1,000 L tank holds about one tonne of water. The tank, stand, fittings and site loads must also be considered. Ask a qualified structural professional to assess the existing support and the new location, especially for a roof or an elevated stand.

A family might want a taller stand because the upstairs shower is weak. Raising the water surface by one metre adds roughly 0.1 bar of static pressure before pipe losses. Ask the plumber to check the pipe and available pressure first. If the cause is a narrow, blocked or partly closed line, a new stand may leave the problem in place.

What a generic stand quote can leave out

A Rajkot supplier’s catalogue lists several tank-base and stand products with different dimensions and heights. A price for a low base cannot tell you the cost of an elevated structure. Ask the supplier to identify the exact item and say whether its quote includes the top platform, corrosion finish, anchoring, freight, lifting and installation. Include the base or foundation work if it is separate.

Practical example

When a taller stand does little for the shower

One extra metre of water height adds roughly 0.1 bar before losses. If a shower is weak only when another tap opens, the plumber can compare flow with one tap running and with both running. Shared pipe restriction can still limit flow after you raise the tank. Get the cause checked before paying for a new stand.

Give the designer a complete brief

Send the tank model and drawing, proposed height, site photos and intended pipe routes. Ask where each support lands and whether the maker requires continuous support under the tank base. Let the designer determine the support details and site loads. For outdoor steelwork, agree how it will be protected from corrosion and inspected later.

Think about where the person cleaning the tank will stand and how they will reach the valves. A platform that leaves the outlet too close to a wall can make repairs awkward. If the old tank rested directly on a base and the new one needs a different footprint, have the existing support checked instead of assuming it will work.

Keep the approved drawing and the tank manual together. If a future owner changes the tank size or asks to move it, those two documents show what the original stand was designed to carry and where its loads go.

Give suppliers the same brief

Send the tank drawing, proposed height, platform location and access photos. Ask the quote to separate design, platform, finish, anchoring and installation.

The best price comparison starts with the same tank, height and site scope. Write these on both quotes, ask who confirms the support, and use the water tank calculator to estimate the water mass for the capacity under consideration.

Sources

Product standard reference for applicable tanks. BIS product manual for rotationally moulded polyethylene water storage tanks.

Back to blog